The cost of gravel ranges from $10 to $50 per ton, $15 to $75 per yard, $1 to $3 per square foot, or $1,350 per truck load depending on the rock type, volume, and travel distance.

What is the cheapest gravel for a driveway?

Crush and run is one of the cheapest materials that can be used in a gravel driveway at about $0.40 per square foot. Cost per cubic yard is about $20 and per ton about $28.

How much should a gravel driveway cost?

According to the Home Depot, 4 to 6 inches of rock or gravel is needed for a driveway. Convert your estimated rock depth in inches to feet by dividing the number of inches by 12.

How much will a ton of gravel cover?

A ton of gravel will cover approximately 100 square feet, 2 inches deep.

How deep should my gravel driveway be?

Driveway Layers A gravel drive should have a first layer of baseball-sized stones at least 4 inches deep. According to Tim Carter of AskTheBuilder.com, each layer thereafter should be 4 inches thick and in gradually smaller stone.

How many square feet will 16 tons of gravel cover?

Using 2 inches for the depth, the following measurements are a guide to the amount of gravel coverage per ton: 1/4 to 1/2 inch gravel, 100 square feet per ton; 1/2 to 1 inch gravel, 90 square feet per ton; and 1 1/2 to 2 inches gravel, 80 square feet per ton.

How many yards is 9 tons of gravel?

6 tons of gravel = 0.714 ×6 = 4.284 cubic yards, 7 tons of gravel = 0.714 ×7 = 4.998 cubic yards, 8 tons of gravel = 0.714 ×8 = 5.712 cubic yards, 9 tons of gravel = 0.714 ×9 = 6.426 cubic yards and 10 tons of gravel = 0.714 ×10 = 7.140 cubic yards.

What is the cheapest surface for a driveway?

Generally, gravel is the cheapest material, with resin and concrete being the most expensive.

How do I figure out how many tons of gravel I need?

Length in feet x Width in feet x Depth in feet (inches divided by 12). Take the total and divide by 21.6 (the amount of cubic feet in a ton). The final figure will be the estimated amount of tons required.

Is a gravel driveway cheaper than concrete?

Gravel is a whole lot cheaper than concrete, asphalt, or another paved surface. It can cost less than 1/2 of paved driveways.

Article first time published on

How many cubic feet are in a ton of gravel?

How much is a ton of gravel? A ton of gravel with average-sized pebbles is about 0.705 cubic yards, or 19 cubic feet, assuming it has been screened for debris and contains no leftover dirt, sand, etc.

Can you put gravel over grass?

It not only suppresses future weed growth, but will also smother existing vegetation, eventually killing it. To convert an unkempt grassy area to pea gravel mulch, simply lay down the fabric and spread the pea gravel on top — the grass will die and decompose in place.

Do I need fabric under gravel driveway?

Is it really necessary to put fabric under my gravel driveway? Yes, if you want your driveway to last. Having geotextile fabric under your gravel driveway will prevent you from continually needing to add more aggregate base to your road since the rock will drop into the subgrade layer.

What is the best gravel for a drive?

The best gravel for a drive should also be a hard wearing stone. Basalts, Granites, Flints and Quartz products are ideal for this application. Darker coloured materials will also hide dirt better.

How many cubic yards does a dump truck hold?

Dump Truck Cubic Yardage – The Basics While there is room for variance, most full-size dump trucks have a capacity of between 10 and 16 cubic yards.

How many yards is a ton of #57 gravel?

Coverage (Square feet)400sq ftVolume (Cubic feet)67cu ftVolume (Cubic yards)2.5cu ydEstimated amount (Pounds)5,951lbEstimated amount (Tons)2.98ton

How much rock is in a ton?

One Ton of Rock Covers:One Cubic Yard Covers:240 square feet1” deep1” deep40 square feet6” deep12” deep20 square feet12” deepAbove approximately for rock up to 1 ½” and sand, soils that are weighed.Above approximately for soil mixes that are sold by the cubic yard.

How many tons of gravel does a dump truck hold?

Typically, larger dump trucks can carry about 28,000 pounds or about 14 tons. On average, smaller dump trucks can transport around 13,000 to 15,000 pounds or 6.5 to 7.5 tons.

How many square feet does a 50 lb bag of gravel cover?

A 50-pound bag of pea gravel is equivalent to 0.5 cubic foot, so two 50-pound bags cover 1 cubic foot. Knowing that a 50-pound bag of pea gravel averages 0.5 cubic foot makes the calculation easy — and one most smartphone calculators can complete.

What does 1 yard of gravel weigh?

One cubic yard of gravel can weigh between 2,400 to 2,900 lbs. Or up to one and a half tons approximately. Generally, a cubic yard of gravel provides enough material to cover a 100-square-foot area with 3 inches of gravel.

How much gravel do I need for a 5 gallon tank?

Generally speaking, you should add about 1 pound of substrate per gallon of water. This means that for a 5-gallon fish tank, a safe bet would be 5 pounds of gravel. Similarly, for a 20-gallon fish tank, roughly 20 pounds of gravel would suffice.

How much gravel do I need for a 10x12 shed?

Gravel base is to be 2 feet larger than the shed size. Example: 10×12 shed requires 12×14 base (see diagram below). Although a level gravel base is best for your shed, buildings 8′ wide or less can be set on additional skids running the width of the building.

What type of rock is used for driveways?

Among the other options are crushed stone #411, quarry process, pea gravel, jersey shore gravel, marble chips, and river rock. These are the best options for driveway surfaces gravel, because they are small stones combined with rock dust, which makes a more solid driving surface.

What do you put under gravel driveway?

For starters, the soil under the gravel driveway must be well drained and strong. It also must be free of any organic material such as sticks, tree roots and leaves or grass. All topsoil must be stripped off the driveway location and stockpiled for use at some other place on your lot.

What is the cheapest way to lay a driveway?

Gravel and Stone Driveways A gravel driveway is by far the cheapest and quickest to install, especially if the existing driveway sub-base is sound.

Are wood chips good for driveways?

Woodchips (often available for free in towns and cities) are an awesome mulch and a great placeholder when you take over an abused property. They’d be perfect for a parking space and good for a driveway, as long as it’s not too steep (they’re going to move a lot more in running water than gravel of the same size).

How long will a gravel driveway last?

With proper care and maintenance, a gravel driveway can last up to 100 years. The beauty of gravel is that it can be repaired and replenished on an ongoing basis. By contrast, wear and damage to asphalt and concrete driveways are difficult to remedy and replacement is often more cost-effective than extensive repairs.

Can you put gravel over blacktop?

Karen, you can place crushed stone on top of the old asphalt. Just be sure it’s at least 4 to 6-inches thick and it contains lots of sharp angular pieces of stone ranging in size from walnuts down to pieces of sand.

Does a gravel driveway add value?

Gravel is typically the most affordable option but it does not add the value of concrete or asphalt.

How many tons are in a yard?

Cubic Yard [yd^3]Ton Register [ton Reg]1 yd^30.27 ton reg2 yd^30.54 ton reg3 yd^30.81 ton reg5 yd^31.35 ton reg

How much is a ton of rock in cubic feet?

Note: The true cubic footage weights are 145-160 pounds per cubic foot, for solid unbroken stone, or about 13 cubic feet per ton on average.